Morton System Saver Water Softeners


Customer Service Store Locator Website Index Warranty Registration

PRODUCTS
Water Softeners
Whole Home Filtration
How To Choose
Warranty Information
Benefits of a Softener
How Softeners Work
Interactive Animation
Softener FAQ

MAINTENANCE
View Animation
Common Maintenance
Troubleshooting
Parts & Accessories
Morton Salt Products

INSTALLATION
System Requirements
Installing Your Softener
Electronics Programming
About Your Plumbing

WATER FACTS
Water Facts
About Hard Water
About Sodium & Water
Testing Your Water
Water Conservation
Water Terms Glossary

Morton Water Treatment Product Installation and Guidelines
Softener Assembly I Planning Installation I Installation Guidelines I Installation

Select Installation Location

Consider all of the following when selecting an installation location for the unit.

To condition all water in the home, install the unit close to the water supply inlet, and before all other plumbing connections, EXCEPT outside water pipes. Outside faucets should remain on hard water to avoid wasting conditioned water and salt.

A nearby drain is needed to carry away regeneration discharge water. Use a floor drain, laundry tub, sump, standpipe, etc., or other options (check your local codes).
The unit works on 24 volts only. A transformer is included to reduce 120-60Hz household electrical power Provide an approved, grounded outlet within 10' of the unit. The unit includes a 10' power cable for connection between the transformer and the timer.
Always install the unit BEFORE the water heater and after all other installed water conditioning equipment

Optional Weather Protection

If installing the unit in an outside location, be sure to provide protection from the elements, contamination, vandalism, and direct sunlight An optional weather cover is available for outdoor installation.

Inlet - Outlet Plumbing Options

Bypass valves allow you to turn off water to the softener for repairs if needed, but still have water in house pipes. ALWAYS INSTALL either a single bypass valve (included) or a 3 valve bypass system (not included). If you choose to install a 3 valve bypass, you will still need to use the included bypass valve to connect to the softener
Use 3/4" (minimum) pipe and fittings
Use sweat copper, or threaded pipe, or PVC plastic pipe, or other approved plumbing.

Tie or wire valve drain hose in place, to keep over floor drain.

NOTE: Air gap requirements.

K+S Privacy Policy Terms and Conditions