SOFTENER ASSEMBLY

Unpacking The Softener

The parts required to assemble and install the unit are included on a heat sealed cardboard insert.

Thoroughly check the unit for possible shipping damage and parts loss. Also inspect and note any damage to the shipping carton. Remove and discard (RECYCLE) all packing materials. To avoid loss of small parts, we suggest you keep the small parts on the sealed cardboard insert until you are ready to use them.

Morton^TM System Saver^TM models come factory assembled.

1. During installation remove the Salt Hole Cover. Set aside to prevent damage. Check the brinewell to be sure it is secured and vertical (see diagram below). Slide Faceplate Cover forward to expose back valve assembly.
2. Lift the brine valve out of the brinewell. Be sure the float stem is parallel to stand tube so seals will seat properly during operation. Replace the brine valve in the brinewell bottom and install the Brinewell Cover.
3. Install the brine tank overflow grommet and elbow in the 3/16" diameter hole in the back of the salt storage tank sidewall.